CCEA A level Life and Health Sciences
20 note di ripasso per CCEA A-Level Life and Health Sciences, create da cookie, in 16 sezioni che seguono gli argomenti del corso.
Revision notes for CCEA A level Life and Health Sciences, one folder for each unit of the specification, in the specification's order. Each note covers the content of one unit's topic, with worked examples. Delete any folder your course leaves out.
Contenuto
La prima nota
Experimental techniques / Practical skills across the sciences
Most of the practical work in this area is quantitative. You measure something, calculate from it, and then judge how far the answer can be trusted. The skills below come up in chemistry, physics and biology, and the method is the same in each.
Making a standard solution
A standard solution is one whose concentration is known accurately. To make one, weigh out a known mass of a pure solid, dissolve it in a small volume of distilled water, transfer it to a volumetric flask and make it up to the graduation line. The flask is calibrated for one volume only, so the final drops are added with a dropping pipette until the bottom of the meniscus sits on the line.
Concentration in mol dm⁻³ is moles divided by volume in dm³. A solid with a molar mass of 40.0 g mol⁻¹, weighed as 4.00 g and made up to 250 cm³, gives 0.100 mol in 0.250 dm³, so the concentration is 0.400 mol dm⁻³.
Titration
In a titration a solution from a burette is added to a measured volume of another solution, usually delivered by a pipette, until the indicator changes colour. The first run is a rough titration to find the approximate end point. The accurate titres are then repeated until two agree within 0.10 cm³ of each other, and the mean of the agreeing titres is used.
A worked example. Exactly 25.0 cm³ of 0.100 mol dm⁻³ sodium hydroxide is titrated with hydrochloric acid, and the mean titre is 24.60 cm³. The reaction is 1:1, so the moles of sodium hydroxide are 0.100 × 0.0250 = 0.00250 mol, which is also the moles of acid. The acid concentration is 0.00250 ÷ 0.02460 = 0.102 mol dm⁻³ to three significant figures.
Qualitative tests
Flame tests identify metal ions by the colour they give to a hot, non-luminous flame. Lithium gives crimson, sodium gives yellow, potassium gives lilac, calcium gives brick red and copper gives blue-green. Tests are used to identify a substance, not to measure it, so a clean wire, a clean flame and a comparison with a known sample are part of the method.
Halide ions are identified by acidifying the solution with dilute nitric acid and then adding silver nitrate. The acid removes carbonate ions, which would otherwise give a precipitate of their own. Chloride gives a white precipitate, bromide a cream one and iodide a yellow one.
Rates and yield
The rate of a reaction is found by measuring something that changes at a steady rate: the volume of gas collected, the mass lost from an open flask, or the time for a colour change to appear. For a reaction that changes quickly at first and then slows, the initial rate is the gradient of a tangent drawn to the curve at time zero.
Percentage yield compares the mass obtained with the mass expected. It is the actual mass divided by the theoretical mass, multiplied by 100. A preparation that gives 4.50 g of product from an expected 6.00 g has a yield of 75.0 per cent. Losses during transfer, filtration and separation lower the yield, so a yield below 100 per cent is normal.
Physics measurements
The period of a pendulum is best found by timing many swings and dividing the total time by the number of swings, because one swing timed by hand carries a large error. For a pendulum of length 1.00 m at g = 9.81 m s⁻², the period is 2π√(L/g) = 2.006 s.
The resistivity of a metal wire is found from ρ = RA/L, where R is found from the voltmeter and ammeter readings, L from a metre rule and A from the diameter, which is measured with a micrometer at several points along the wire.
The focal length of a converging lens is found from 1/f = 1/u + 1/v. A lens that forms a sharp image on a screen 60 cm away from an object 30 cm from the lens has 1/f = 1/30 + 1/60 = 1/20, so f = 20 cm.
Biology measurements
Reducing sugars are detected with Benedict's reagent, which turns from blue to a brick-red precipitate on heating. Starch turns iodine solution blue-black. Protein turns biuret reagent purple. Lipids form a cloudy white emulsion when a sample shaken with ethanol is poured into water.
A colorimeter measures how much light a coloured solution absorbs. Absorbance readings for several known concentrations give a calibration curve, and an unknown is read off the same curve. Osmosis experiments use pieces of potato in sucrose solutions of different concentrations. The change in mass is plotted against concentration, and the concentration at which the mass does not change is the one isotonic with the potato cells.
E altri 19: aprine uno qualsiasi dall’elenco qui sopra.
Valutazioni
Non ci sono ancora recensioni scritte. Aggiungi queste note alle tue e potrai essere il primo a lasciarne una.