ข้ามไปยังเนื้อหา
cookie

CCEA GCSE Geography

GCSE · CCEAGeography20 โน้ต ใน 9 โฟลเดอร์, 66 KB

โน้ตทบทวน 20 รายการ สร้างโดย cookie แบ่งเป็น 9 ส่วนตามหัวข้อของหลักสูตร

Notes for CCEA GCSE Geography (3910), in folders for the four themes of Unit 1, the four themes of Unit 2, the fieldwork unit and the skills and concepts that run through the course, in the specification's order. They follow the 2017 specification as revised in 2022, for exams from 2027. Delete any folder your course leaves out once the notes are yours.

มีอะไรอยู่ข้างใน

โน้ตรายการแรก

River environments / Drainage basins and the water cycle

A drainage basin is the area of land drained by a river and its tributaries. Its edge is the watershed, the line of high ground that separates one basin from the next. Water that falls inside the watershed ends up in the same river, so the basin is a convenient unit for studying how water moves over land.

Water enters the basin as precipitation, mainly rain and snow. Some of it is held by plants and buildings before it reaches the ground. This store is called interception, and it is greatest where there is dense vegetation. Water that reaches the ground does one of several things, and each of these is a transfer within the basin.

Transfers of water

Surface runoff, also called overland flow, is water that moves across the ground surface towards a river. It happens when the rain arrives faster than the soil can absorb it, or when the ground is already saturated. Surface runoff reaches the river quickly, so it is a major cause of rapid rises in river level after heavy rain.

Infiltration is water soaking into the ground from the surface. Once it is in the soil, it can move in two ways. Throughflow is water moving sideways through the upper soil, usually towards a river. Percolation is water moving downwards through the soil and rock. Water that reaches the saturated zone becomes groundwater, and groundwater flow is its slow movement through rock below the water table towards a river.

Throughflow and groundwater flow are much slower than surface runoff. This is why a river can keep flowing for weeks after rain has stopped, fed by water stored underground.

Outputs from the basin

A drainage basin has two outputs. River discharge is the volume of water leaving the basin in the river. Evapotranspiration is the loss of water to the atmosphere, through evaporation from the surface of water, soil and plants, and through transpiration from the leaves of plants.

Discharge is measured as the volume of water passing a point each second. It changes with the amount of rain, the speed at which water reaches the river, and the amount of water already stored in the basin. Evapotranspiration is higher in warm, sunny conditions and where plant cover is dense.

A simple way to set out the basin's balance is to compare inputs with outputs. Over a long period, the precipitation entering the basin is roughly balanced by river discharge and evapotranspiration, with some water added to or taken from storage. A basin that receives more rain than it loses in discharge and evapotranspiration is building up stored water.

Features of a river system

The source of a river is where it starts, often in high ground. A tributary is a smaller river that flows into a larger one. A confluence is the point where two rivers meet. The river mouth is the place where the river reaches the sea or a lake. A river therefore has many tributaries and confluences, but only one source and one mouth.

The long profile describes how the river changes from source to mouth. Gradient falls steadily along the profile, so the river flows more slowly at its mouth than at its source. Depth and width increase downstream as more water joins the river from tributaries and the surface runoff they carry. Discharge increases for the same reason. The valley changes too: upstream it is steep and narrow, usually V-shaped, and downstream it becomes wider with a flatter floor.

The load carried by the river also changes. Material is broken down and rounded as it travels, so the size of particles decreases downstream. This happens because of the processes that act on the river's load as well as on its bed and banks, described in the next section of the folder's river processes note.

Why the basin matters

Every process that acts on a river begins with water arriving in the basin. Changes to the basin, such as clearing woodland, paving land for roads or building drainage, change how the water moves. They alter the balance between surface runoff and infiltration, and so change how quickly water reaches the river and how high it rises. That is the link between land use and flooding, which is discussed under flooding and river management.

และอีก 19 รายการ: เปิดรายการใดก็ได้จากรายการด้านบน

รีวิว

ยังไม่มีรีวิวที่เขียนไว้ เพิ่มโน้ตเหล่านี้ลงในของคุณ แล้วคุณจะเป็นคนแรกที่เขียนรีวิว